Logo

C1735 Engine Trouble Code

Meaning of C1735 engine trouble code is a kind of chassis trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

C1735 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for C1735 code is occuring now you should check C1735 repair processes.
Now don't ask yourself; What should you do with C1735 code ?
The solution is here :

C1735 Possible Solution:

C1735 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

C1735 Code Meaning :

C 1 7 3 5
OBD-II Diagnostic Chassis (C) Trouble Code For Engine Fuel And Air Metering Fuel Rail Pressure Sensor Circuit Malfunction Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector) Crankshaft Position Sensor B Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

C1735 OBD-II Diagnostic Chassis (C) Trouble Code Description

C1735 engine trouble code is about Crankshaft Position Sensor B Circuit Malfunction.

Main reason For C1735 Code

The reason of C1735 OBD-II Engine Trouble Code is Fuel Rail Pressure Sensor Circuit Malfunction.

C1735 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.